Park Avenue V6-3.8L SC VIN 1 (2005)
9. insert the properly formed mandrel (3) into the J 29803-A.
10. Hold the forming mandrel (3) in place using your finger.
11. Thread in the forcing screw (2) until contact is made and the screw begins to move the forming mandrel (3).
12. Turn the forcing screw back one complete turn.
13. Slide the clamping nut over the brake pipe.
14. Insert the prepared brake pipe into the correct collet (2).
^
Leave approximately 19 mm (0.750 inch) of tubing extending out of the collet.
^
Insert the assembly into the J 29803-A.
^
Ensure that the brake pipe end contacts the face of the forming mandrel.
15. Tighten the clamping nut (1) into the J29803-A body tightly in order to ensure that the pipe will not push out.
Important: Do not over tighten the forcing screw or the flare may become oversized.
16. Wrench tighten the forcing screw until the screw bottoms.
17. Back the clamping nut (1) out of the J 29803-A.
18. Disassemble the clamping nut (1) and the collet assembly.
19. Measure the flare diameter. It should fall between 6.92 mm and 7.28 mm (0.272 inch and 0.286 inch).
