Park Avenue V6-3.8L SC VIN 1 (2005)
Air Cleaner Fresh Air Duct/Hose: Service and Repair
AIR CLEANER INTAKE DUCT REPLACEMENT
REMOVAL PROCEDURE
1. Remove the intake air temperature (IAT) sensor electrical connector (1) from the IAT sensor (2).
2. Loosen the intake air duct clamp.
3. Remove the intake air duct from the air cleaner and rotate the duct upwards.
4. Remove the intake air duct from the throttle body by pulling upwards and inboard.
INSTALLATION PROCEDURE
1. Install the intake air duct onto the throttle body.
2. Rotate the intake air duct down and install the intake air duct onto the air cleaner.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the air cleaner duct clamp to 2 N.m (18 lb in).
3. Install the intake air temperature (IAT) sensor electrical connector (1) to the IAT sensor (2).
