Park Avenue V6-3.8L SC VIN 1 (2005)
13. Remove the right engine lift bracket retaining fasteners.
14. Remove the right engine lift bracket.
15. Remove the bolt (1) securing the EGR inlet pipe to the right exhaust manifold.
16. Remove the right exhaust manifold retaining fasteners.
17. Remove the right exhaust manifold and the gasket from the engine. Do not reuse the gasket.
18. Remove the exhaust crossover seal from the exhaust crossover. Do not reuse the seal.
19. Clean and inspect the right exhaust manifold.
Installation Procedure
1. Place a NEW exhaust crossover seal over the exhaust crossover.
2. Place a NEW exhaust manifold gasket over the cylinder head studs.
3. Position the right exhaust manifold around the exhaust crossover and up to the right cylinder head.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the right exhaust manifold fasteners.
