Park Avenue V6-3.8L SC VIN 1 (2005)
8. Connect the steering wheel module coil yellow connector (4) to the vehicle yellow harness connector (3).
9. Install the CPA (1) to the steering wheel module coil yellow connector (4).
10. Install the LH insulator panel.
11. Connect the vehicle harness yellow connector (2) to the LF side impact module yellow connector (1).
12. Install the CPA (3) to the LF side impact module yellow connector (1).
13. Install the SIR fuse into the underhood fuse center.
14. Install the fuse center cover.
15. Using caution while reaching in, turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
16. Perform the Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check -
Vehicle in Vehicle DTC Information.