Park Avenue V6-3.8L SC VIN 1 (2005)
1. Position the new fuel sender seal on the fuel tank.
IMPORTANT:
-
DO NOT fold over or twist the fuel pump strainer when installing the fuel sender assembly, as this will restrict fuel flow. Ensure that the fuel pump
strainer does not block the full travel of the float arm.
-
Always replace the fuel sender seal when reinstalling the fuel sender.
2. Install the fuel sender assembly and the fuel sender lock ring using the J 39765.
3. Connect the quick-connect fittings at the fuel sender.
4. Connect the fuel sender electrical connector.
5. Connect the fuel tank pressure sensor electrical connector.
6. Add fuel to the fuel tank.
7. Install the fuel tank filler pipe cap.
8. Connect the negative battery cable.
9. Inspect for leaks.
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
10. Install the fuel sender access panel.
11. Install the fuel sender access panel bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the fuel sender access panel bolts to 2 N.m (18 lb in).
12. Install the rear compartment floor trim.
13. Install the fuel injector sight shield.
