Park Avenue V6-3.8L SC VIN 1 (2005)
IMPORTANT:
-
The rear hoist pads must not contact the rocker panels outside of the frame rail reinforcements.
-
The rear hoist pads must not contact the floor pan.
Position the frame contact rear hoist pads as follows:
-
Under the rear frame rail reinforcements
-
The long sides of the pads perpendicular to the frame rails
-
The outer edge of the pads aligned with the outer edge of the rear frame rail reinforcements
SUSPENSION CONTACT HOIST
Rear Lift
Position the suspension contact rear lift as follows:
Under the rear tire and wheel assemblies
Front Lift
NOTE: Ensure that the front suspension-contact lift points contact the lower control arms ONLY where identified. Failure to follow this
precautionary step could result in damage to the lower control arm stabilizer link bracket.
Position the hoist-to-vehicle contact points as shown.
When lifting the vehicle with a suspension-contact lift, place the front post lift points at the lower control arms (1).
JACKING
IMPORTANT: Jacking on the control arms is not recommended.
When you are lifting a vehicle with a vehicle jack or a floor jack, block the wheels at the opposite end from which you are lifting. Use jack stands to
provide additional support.
Under The Frame Rails
