Park Avenue V6-3.8L SC VIN 1 (2005)
1. Position the crankshaft position (CKP) sensor to the block.
2. Install the bolts that hold the CKP sensor to the block face.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 30 N.m (22 lb ft).
3. Install the crankshaft position sensor shield (1).
4. Connect the CKP sensor electrical connector.
5. Position the crankshaft harmonic balancer on the crankshaft.
6. Install the right splash shield cover.
7. Lower the vehicle.
8. Connect the negative battery cable.
9. Perform the crankshaft position (CKP) system variation learn procedure. See: Testing and Inspection/Programming and Relearning
