Park Avenue V6-3.8L SC VIN 1 (2005)
Memory Positioning Module: Service and Repair
Memory Seat Control Module Replacement
MEMORY SEAT CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Raise the seat to the full upright position.
2. Unsnap the front track cover from the seat by sliding forward.
3. Remove the 2 front screws from the memory seat module bracket.
4. Remove the front seat anchor bolts from the rear of the seat tracks.
5. Raise and support the rear of the seat assembly.
6. Disconnect the electrical connector.
7. Remove the 2 rear fasteners from the bracket.
8. Remove the memory seat module (1) and the bracket.
INSTALLATION PROCEDURE
1. Install the memory seat module (1) and the bracket.
2. Install the 2 rear fasteners to the bracket.
3. Connect the electrical connector.
4. Install the seat.
5. Install the seat anchor bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the seat anchor bolts to 41 N.m (30 lb ft).
6. Install the 2 front fasteners to the bracket.
7. Install the front track cover.
8. Calibrate the seat. Refer to Memory Seat Calibration Procedure.
