Park Avenue V6-3.8L SC VIN 1 (2005)
Relay Box: Service and Repair
Instrument Panel Electrical Center or Junction Block Replacement
INSTRUMENT PANEL ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right closeout/insulator panel.
2. Remove the 2 fasteners from the relay/fuse center (1) at the lower instrument panel.
3. Remove the fastener from the forward side of the IP carrier above the relay/fuse center (1).
4. Disengage the 4 cam locks that secure the harness connectors to the relay/fuse center (1).Pull down on the tabs.
5. Remove the relay/fuse center (1) from the IP.
INSTALLATION PROCEDURE
1. Align the relay/fuse center (1) to the lower IP.
2. Install the harness connectors to the relay/fuse center (1).Engage the cam locks.
3. Install the fasteners.
4. Install the right closeout/insulator panel.
