Park Avenue V6-3.8L SC VIN 1 (2005)
1. Route the inflatable restraint I/P module pigtail (4) down through the I/P (1).
IMPORTANT: When installing the inflatable restraint I/P module (3), do not damage the inflatable restraint I/P module pigtail (4).
2. Install the inflatable restraint I/P module (3) to the I/P (1).
3. Install the mounting fasteners (2) to the inflatable restraint I/P module.
Tighten the fasteners to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Route the wiring harness (2) to the inflatable restraint I/P module in place in order to secure the yellow connector clip to the I/P (3).
5. Install the I/P upper trim pad.
6. Clip the yellow connector (2) on the inflatable restraint I/P module to the I/P bracket (3).
7. Install the yellow connector (2) on the inflatable restraint I/P module to the yellow connector (1) on the vehicle harness.
8. Install the CPA (4) to the inflatable restraint I/P module connector (2).
9. Install the right insulator panel.
10. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5.
