Park Avenue V6-3.8L SC VIN 1 (2005)
5. Remove the inflatable restraint side impact module (1) from the seat (2).
6. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period.
7. Remove the connector position assurance (CPA) (4) from the inflatable restraint side impact module electrical connector (5).
8. Disconnect the electrical connector (5) from the inflatable restraint side impact module (1).
INSTALLATION PROCEDURE
1. Install a new inflatable restraint retainer. Push in the fastener (6) to the inflatable restraint side impact module (1) when replacing the module.
IMPORTANT: After a deployment or replacement, both retainer fasteners (3,6) must be replaced in order to ensure the proper module positioning.
2. Install a new retainer fastener (3) to the seat (2) when replacing the module.
3. Connect the electrical connector (5) to the inflatable restraint side impact module (1).
4. Install the CPA (4) to the electrical connector (5) on the inflatable restraint side impact module.
5. Install the inflatable restraint side impact module (1) to the seat (2).
6. Install the 2 fasteners (1) to the inflatable restraint side impact module.
Tighten the nuts to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the seat back panel (2) to the seat (1) by sliding the top of the panel up into place and pushing the bottom of the panel in and then down
until the hook retainers are secure.
8. Install the seat to the original position.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9.