Park Avenue V6-3.8L SC VIN 1 (2005)
Yaw Rate Sensor: Service and Repair
Yaw Rate Sensor Replacement
Removal Procedure
1. Turn OFF the ignition.
2. Remove the rear compartment trim.
3. Remove the rear shelf trim panel.
4. Remove the 2 yaw rate sensor mounting nuts (1).
5. Remove the yaw rate sensor (2).
6. Disconnect the yaw rate sensor electrical connector (3).
Installation Procedure
1. Connect the yaw rate sensor electrical connector (3).
2. Install the yaw rate sensor.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the yaw rate sensor nuts (1).
Tighten the yaw rate sensor mounting nuts to 6 Nm (53 inch lbs.).
4. Install the rear shelf trim panel.
5. Install the rear compartment trim.
6. Perform the ABS Diagnostic System Check. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check -
Vehicle
