Park Avenue V6-3.8L SC VIN 1 (2005)
9. Remove the left air temperature sensor from the air distributor duct by turning the sensor counterclockwise 1/4 turn.
10. Disconnect the air temperature sensor electrical connector.
INSTALLATION PROCEDURE
1. Connect the air temperature sensor electrical connector to the sensor.
2. Install the left air temperature sensor into the air distributor duct and turn clockwise 1/4 turn.
3. Install the air distributor duct.
4. Install the air distributor duct outboard screws.
Tighten the screws to 2 N.m (17 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the air distributor duct center screws (1).
Tighten the screws to 2 N.m (17 lb in).
6. Align the lower I/P trim to the studs.
