Park Avenue V6-3.8L SC VIN 1 (2005)
Fuse Block: Service and Repair
Underhood Electrical Center or Junction Block Replacement
UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the battery cable at the fuse block.
2. Remove the MaxiFuse(R) holder from the electrical center base.
3. Use the following steps in order to remove the cover from the electrical center base:
-
Remove the 2 screws on the side near the MaxiFuse(R) holder.
-
Pull upward and slide the fuse to the left in order to release the fuse block.
-
Remove the electrical connectors from the fuse block and put them aside.
-
Remove the fuse block from the electrical center base.
4. Remove the 3 fasteners (3) securing the electrical center base to the vehicle.
INSTALLATION PROCEDURE
1. Install the electrical center base to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
