Park Avenue V6-3.8L SC VIN 1 (2005)
Install the transmission side case bolts.
^
Tighten all bolts to 25 Nm (18 ft. lbs.).
4. If removed, install the transmission mount bracket.
5. Install the drive axle into the transaxle.
6. Lower the vehicle enough to gain access to the engine support fixture.
7. Using the engine support fixture, raise the transaxle to the original position.
8. Raise the vehicle.
9. Install the left transaxle mount nut.
^
Tighten the bolts to 80 Nm (59 ft. lbs.).
10. Using an appropriate jack. Carefully raise the left side of the frame so that the frame-to-body bolts can be installed.
11. Using 16 mm (0.630 inch) dowel pins in the alignment holes (1), align the engine frame (2) with the body.
12. Install the frame-to-body bolts (3).
^
Tighten the bolts to 112 Nm (83 ft. lbs.).
13. Remove the jack stand and oil drain pan.
14. Install the lower nut (1) onto the front transaxle mount.
^
Tighten the nut to 70 Nm (52 ft. lbs.).
15. Install the two lower bolts and lower nut onto the rear transaxle mount (1).
^
Tighten the two lower bolts and lower nut to 50 Nm (37 ft. lbs.).
