Park Avenue V6-3.8L SC VIN 1 (2005)
11. Place approximately half the grease from the service kit inside the outboard seal and pack the CV joint with the remaining grease.
12. Push the CV joint (2) onto the halfshaft bar (1) until the retaining ring is seated in the groove on the bar.
13. Important: The outboard seal (1) must not be dimpled, stretched or out of shape in any way. If the seal (1) is not shaped correctly, equalize the
pressure in the seal (1) and shape the seal (1) properly by hand.
Slide large diameter of the outboard seal (1) with the large seal retaining clamp (2) in place over the outside of the CV joint outer race (3) and
locate the seal lip in the groove on the CV joint outer race (3).
