Park Avenue V6-3.8L SC VIN 1 (2005)
1. Place the new small swage ring (2) onto the small end of the joint seal (1). Slide the joint seal (1) and the small swage ring (2) onto the halfshaft
bar.
2. Position the small end of the joint seal (1) into the joint seal groove (3) on the halfshaft bar.
3. Mount J 41048 in a vise and proceed as follows:
1. Position the inboard end (1) of the halfshaft assembly in tool J 41048 .
2. Align the top of seal neck on the bottom die using the indicator.
3. Place the top half of the J 41048 on the lower half of the J 41048 .
4. Before proceeding, ensure there are no pinch points on the halfshaft inboard seal. This could cause damage to the halfshaft inboard seal.
5. Insert the bolts (2).
6. Tighten the bolts by hand until snug.