Park Avenue V6-3.8L SC VIN 1 (2005)
Wiper Motor: Service and Repair
Wiper Motor Cover Replacement
WIPER MOTOR COVER REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the harness electrical connector from the wiper motor cover.
2. Remove three screws from the wiper motor cover.
3. Remove the wiper motor cover from the wiper motor assembly.
INSTALLATION PROCEDURE
1. Position the wiper motor cover to the wiper motor assembly.
2. Install the 3 screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 3 N.m (26 lb in).
3. Connect the harness electrical connector to the wiper motor cover.
4. Verify the wiper motor operation.
