Park Avenue V6-3.8L VIN K (1995)
PROM - Programmable Read Only Memory: Recalls
Service Procedure & Campaign Identification Label
SERVICE PROCEDURE
1.
With ignition in the "OFF" position, open hood and disconnect negative battery cable.
2.
Remove instrument panel right sound insulator.
3.
Pull bottom of PCM away from mounting bracket and remove PCM from bracket.
4.
Remove harness connectors from PCM.
5.
Remove PCM from vehicle.
6.
Remove MEM-CAL access cover.
7.
Remove MEM-CAL by using thumb and first finger. Gently squeeze each end of the blue calibrator unit.
8.
Install new MEM-CAL in PCM.
9.
Install MEM-CAL access cover.
10.
Install connectors to PCM.
11.
Install PCM in mounting bracket.
12.
Install instrument panel right sound insulator.
13.
Install negative battery cable.
14.
Perform on-board diagnostic system check.
15.
If DTC P0325, P1361, P1350, or P1623 occurs or if the MIL (Service Engine Soon) light is "ON" constantly with no DTC's, the engine
MEM-CAL is not fully seated or is defective.
16.
Install Campaign Identification Label.
CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with the instruction outlined in this bulletin will require a "Campaign Identification Label". Each label provides a
space to include the five (5) digit dealer code of the dealer performing the campaign service. This information may be inserted with a typewriter or
ballpoint pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner.
Apply "Campaign Identification Label" only on a clean dry surface.
