Park Avenue Ultra V6-3.8L SC VIN 1 (1991)
NOTE:
Do not allow debris to enter sensor housing. Do not add lubricant to the bearing through sensor housing opening. Do not clean grease from the
toothed sensor ring.
9.
Install loosely, three new sensor attaching screws. TIGHTEN sensor attaching screws to 2.8 N-m (25 lb.in.) in the order shown in Figure 2, using
tool J39860.
10.
Install new seal onto existing connector body.
11.
Install connector (Figure 2, # 4) to rear wheel speed sensor.
NOTE:
The connector bodies are shaped to only allow installation one way. Install connector so that latches on connector snap over tabs on sensor.
12.
Install lower strut attaching bolt and nut, tighten to 190 N-m (140 lb.ft.).
13.
Repeat steps 2 through 12 for opposite rear wheel speed sensors.
14.
Lower vehicle. Clear codes and road test the vehicle before replacing any other Antilock System Component.
Parts are currently available from GMSPO.
WARRANTY INFORMATION:
For vehicles repaired under warranty, use:
Replace both rear wheel speed sensors on vehicle.
Labor Operation Number: T5305
Labor Time: 0.7
If hub and bearing assembly(ies) replacement is required, refer to Labor Time Guide for applicable E-operation number.
