Park Avenue Ultra V6-3.8L SC VIN 1 (1991)
9.
Install drums and wheel and tire assemblies, aligning marks made at removal.
10.
Lower vehicle.
11.
Torque wheel nuts to 140 N-m (100 lb.ft.).
12.
Apply and release service brake pedal 30 to 35 times with normal pedal force. Pause about one (1) second between pedal applies.
13.
Apply and release parking brake five (5) times to 10 clicks. Release park brake pedal.
14.
Check park brake pedal for full release by turning ignition to "ON" and checking the "BRAKE" indicator light. The light should be off. If the light
is on and the brake appears to be released, operate pedal release lever and pull downward on the front parking brake cable to remove slack.
15.
Raise vehicle and suitably support.
16.
Remove access hole plug in rear brake backing plates.
17.
Adjust parking brake cable until a 1/8-inch drill bit can be inserted through access hole in space between shoe web (11) and park brake lever (12).
(Refer to Figure 4). Satisfactory cable adjustment is achieved when a 1/8-inch bit will fit into the space, but a 1/4-inch bit will not.
18.
Apply park brake to four clicks. The wheels should not move when one attempts to rotate it (by hand) in a forward direction. The wheel should
drag or not move when attempting to rotate in a rearward direction.
19.
Release park brake and check for free wheel rotation.
20.
Reinstall access hole plugs.
21.
Lower vehicle.
22.
Install Campaign Identification Label.
