Park Avenue Ultra V6-3.8L SC VIN 1 (1991)
10.
Remove parking brake lever assembly.
11.
Transfer swibch (10) and plastic shield (if so equipped) to new parking brake lever assembly.
12.
Reverse steps 5 through 10 to install new lever assembly.
CAUTION:
Parking brake cable and lever assembly are to be routed left of transmission shift cable. Do not place brake cable or lever assembly over shift cable.
Torque two nuts at upper rear locations (2) and nut at lower front location (4) to 18 N-m (13 lb.ft.).
13.
Enable the SIR System (Refer to appropriate Electrical Systems Manual).
14.
Reinstall left lower IP sound insulator.
15.
With the ignition in the off position, reconnect the negative battery cable and remove memory retention device if used. In the interest of customer
satisfaction, please advise customer that the battery was disconnected (not required if a memory retention tool was used) and memory in the radio,
clock, or other memory options may need resetting.
Parking Brake Cable Adjustment:
1.
Raise vehicle and suitably support (Refer to Service Manual section OA).
2.
Mark relationship of rear wheel to wheel studs in bearing flange.
3.
Remove rear wheel and tire assemblies.
4.
Mark relationship of rear drum to wheel studs in bearing flange.
5.
Remove brake drums.
