Park Avenue Ultra V6-3.8L SC VIN 1 (1991)
Starter Motor: Service and Repair
When removing starter, note if any shims are used between the starter and mounting surface. If shims are found, reinstall in original locations. If
starter is noisy during cranking, remove one .015 inch double shim or add one .015 inch single shim to the outer bolt. If starter makes a high pitched
whine after engine start, add .015 inch double shims until noise ceases.
1.
Disable airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2.
Disconnect battery ground cable and raise and support vehicle.
3.
Remove starter braces, shields or other components that may hinder starter removal.
4.
Support starter and remove mounting bolts.
5.
Lower starter and disconnect solenoid wires and battery cable.
6.
Remove starter from vehicle.
7.
Reverse procedure to install.
8.
Rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
