Rainier 2WD L6-4.2L VIN S (2005)
installed.
Install the brake rotor by slowly turning the rotor while pushing the rotor on the axle flange.
6. Install the rear brake caliper mounting bracket.
7. Install the tire and wheel assembly.
8. Lower the vehicle. Refer to Vehicle Lifting.
9. Refill the brake master cylinder reservoir, if needed.
10. Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
Pump the brake pedal slowly and firmly in order to seat the brake pads.
11. Burnish replaced or refinished rotors.
