Rainier 2WD L6-4.2L VIN S (2005)
Brake Rotor/Disc: Specifications
Front Brakes
^
Rotor Discard Thickness * ........................................................................................................................................................... 27.5 mm (1.08 inch)
^
Rotor Thickness (new) ................................................................................................................................................................. 29.0 mm (1.14 inch)
^
Rotor Maximum Allowable Lateral Runout ................................................................................................................................ 0.051 mm (0.002 in)
^
Rotor Maximum Allowable Scoring .............................................................................................................................................. 1.50 mm (0.059 in)
^
Rotor Maximum Allowable Thickness Variation ........................................................................................................................ 0.025 mm (0.001 in)
Rear Brakes
^
Rotor Discard Thickness * .......................................................................................................................................................... 18.50 mm (0.728 in)
^
Rotor Thickness (new) .................................................................................................................................................................. 20.0 mm (0.787 in)
^
Rotor Maximum Allowable Lateral Runout ................................................................................................................................ 0.051 mm (0.002 in)
^
Rotor Maximum Allowable Scoring .............................................................................................................................................. 1.50 mm (0.059 in)
^
Rotor Maximum Allowable Thickness Variation ........................................................................................................................ 0.025 mm (0.001 in)
*
All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor,
replace any rotor that does not meet the minimum thickness specifications.
