Rainier 2WD L6-4.2L VIN S (2005)
7. Install the camshaft caps onto their original journal.
Tighten the camshaft cap bolts to 12 Nm (106 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
8. Carefully move the camshaft sprockets back onto the camshafts and remove the J 44222.
9. Install the intake camshaft sprocket washer, and the bolt, and the exhaust camshaft actuator bolt.
^
Tighten the intake camshaft sprocket bolt the first pass 20 Nm (15 ft. lbs.).
^
Use the J 36660-A to tighten the intake camshaft sprocket bolt the final pass and additional 100 degrees.
^
Tighten the exhaust camshaft actuator bolt the first pass to 25 Nm (18 ft. lbs.).
^
Use the J 36660-A to tighten the exhaust camshaft actuator bolt a final pass an additional 135 degrees.
10. Install the camshaft cover.
