Rainier 2WD L6-4.2L VIN S (2005)
Engine Mount: Service and Repair
Engine Mount and Bracket Replacement- Left
Engine Mount and Bracket Replacement - Left
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the cooling fan in Engine Cooling.
3. Remove the manifold absolute pressure (MAP) sensor electrical connector and the retainer (1).
4. Remove the MAP sensor (2).
5. Remove the left shock module (if frame mount is being removed).
6. Remove the right and the left upper engine mount nuts (1).
7. Raise the vehicle. Refer to Vehicle Lifting.
8. Remove the right and the left lower engine mount nuts.
9. Remove the engine protection shield.
Important: When placing jack onto the oil pan, pay close attention to not damage the oil level sender.
10. Lower the vehicle and place a floor jack under the oil pan with a block of wood.
11. Raise the engine with the jack just enough to clear the engine mount stud.
