Rainier 2WD L6-4.2L VIN S (2005)
License Plate Lamp: Service and Repair
LICENSE LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Remove the 2 screws that retain the license lamp lens to the liftgate.
2. Remove the license lamp lens from the liftgate.
3. Remove the bulb (1) from the socket.
INSTALLATION PROCEDURE
1. Install the bulb (1) to the socket.
2. Wipe the bulb to ensure the bulb is free of dirt or oil.
3. Position the license lamp lens to the liftgate.
4. Verify that the license lamp lens gasket is fully seated to the liftgate.
5. Install the 2 license lamp lens retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.4 N.m (12 lb in).
