Rainier 2WD L6-4.2L VIN S (2005)
Suspension Control Module: Service and Repair
Shock Module Replacement
Shock Module Replacement
Tools Required
^
J24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Remove the shock module upper retaining nuts.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in
premature failure of the coil springs.
3. Remove the tire and wheel.
4. Remove the shock module yoke to lower control arm retaining nut.
5. Remove the shock module yoke from the lower control arm using J24319-B.
