Rainier 2WD L6-4.2L VIN S (2005)
Installation Procedure
1. Install the steering wheel to the steering wheel shaft.
2. Notice: Refer to Fastener in Service Precautions.
Install the retaining nut that secures the steering wheel to the steering wheel shaft.
Tighten the retaining nut to 41 Nm (30 ft. lbs.).
3. Connect the steering wheel electrical connector.
4. Install the horn plunger to the steering column.
5. Install the inflator module.
6. Enable the Restraint Systems. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
