Rainier 2WD L6-4.2L VIN S (2005)
12. Remove the 2-4 servo from the transmission.
13. Inspect the 4th apply piston, 2-4 servo converter, 2nd apply piston, and the servo piston inner housing for the following defects.
^
Cracks
^
Scoring
^
Burrs and nicks
Installation Procedure
1. Install new seals on the servo pistons and the servo cover.
2. Install the 2-4 servo assembly into the transmission.
3. Install the J29714-A.
4. Tighten the bolt in order to compress the servo cover.
5. Install the servo cover retaining ring.
6. Remove the J29714-A from the oil pan flange.
7. Notice: Refer to Fastener Notice in Service Precautions.
Install the transmission oil pan bolt.
Tighten the bolt to 11 Nm (97 inch lbs.).
8. Install the heat shield if equipped.
9. Install the exhaust pipe assembly.
10. Install the transmission support.
11. Remove the transmission jack.
12. Lower the vehicle.
13. Fill the transmission to the proper level with DEXRON(r) III transmission fluid.
