Rainier 2WD V8-5.3L VIN P (2004)
11.
Install the three torque head screws.
Tighten
Tighten the torque head screws to 10 Nm (89 lb-in.).
12.
Install the wire harness if equipped with heated mirror and turn signal.
13.
Line up the mirror back with the actuator. Press firmly in the center of the glass using the palm of your hand. The mirror and backing plate will
snap onto the actuator.
14.
Make sure the mirror is locked in by lightly pulling on the mirror glass. Check the operation of the mirror and clean the glass.
Parts Information
Parts are expected to be available from GMSPO on September 24, 2003.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer