Rainier 2WD V8-5.3L VIN P (2004)
9. Install the drive cable retainer to the upper right corner of the steering column support.
IMPORTANT: The following procedure must be performed before the installation of the drive motor and cable assembly. Failure to do so could
cause an IMPROPER STEP OVER HEIGHT.
10. Adjust the accelerator pedal in the following manner:
10.1. Turning the motor transmission clockwise reduces the gap, and counterclockwise increases the gap.
10.2. Position the drill bit 4.5 mm (0.187 in-3/16 or the equivalent in number and or letter drill bits) a 1/4 of an inch from the bottom of the metal
accelerator pivot arm.
10.3. Rotating the drive cable by hand, adjust the accelerator motor transmission until the drill 4.5 mm (0.187 in-3/16 or the equivalent in number
and or letter drill) bit fits snugly between the plastic accelerator arm and the metal pivot arm.
