Rainier 2WD V8-5.3L VIN P (2004)
IMPORTANT: If replacing the condenser, add the refrigerant oil to the condenser. Refer to Refrigerant System Capacities for the capacity
information.
1. Install the condenser to the radiator.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
2. Install the retaining screws to the condenser.
Tighten
Tighten the screws to 5 N.m (44 lb in).
3. Connect the evaporator tube (4) to the condenser (3).
4. Install the retaining nut to the evaporator tube (4) at the condenser (3).
Tighten
Tighten the nut to 28 N.m (21 lb ft).
5. Connect the compressor discharge hose (2) to the condenser (4).
6. Install the retaining nut (1) to the compressor discharge hose (2) at the condenser (4).
Tighten
Tighten the nut to 28 N.m (21 lb ft).
7. Install the hood latch support.
8. Evacuate and recharge the A/C system.