Rainier 2WD V8-5.3L VIN P (2004)
1.
Remove the 2 screws that retain the insulator panel to the instrument panel (I/P).
2.
Release the insulator panel retaining clip from the I/P substrate.
3.
Lower the insulator panel.
4.
Remove the flasher retaining bracket from the insulator panel.
5.
Disconnect the flasher from the electrical connector.
6.
Remove the flasher from the vehicle.
7.
Position the new flasher to the insulator panel.
8.
Connect the electrical connector to the flasher.
9.
Install the flasher retaining bracket to the insulator panel.
10.
Install the insulator panel tabs to the cowl slots.
11.
Raise the insulator panel to the I/P.
12.
Install the insulator panel retaining clip to the I/P substrate.
13.
Install the 2 screws that retain the insulator panel to the I/P.
Tighten
Tighten the screws to 2.5 N.m (22 lb in).
