Rainier AWD L6-4.2L (2007)
Install the lock striker screws that retain the lock striker to the door opening.
Tighten the lock striker screws that retain the lock striker to the door opening.
Tighten the lock striker screws only until the screw heads are flush to the lock striker plate, but still allowing the striker to move.
Using a large flat-bladed tool, rock the striker up and down in order to loosen the striker backing plate from the body.
Do not slam the door.
Close the door while holding the outside handle in the open position in order to align the lock striker. If necessary, adjust the striker position in order to
allow the door to close with minimum effort.
Open the door.
Finish tightening the lock striker screws.
Tighten
Tighten the lock striker screws to 25 N.m (18 lb ft).
Verify proper door operation.
Warranty Information (excluding Saab U.S Models)
For vehicles repaired under warranty, use the table.
Warranty Information (Saab U.S Models)
For 2005 and 2006 vehicles - Adjustment of the striker plate is only covered for 1 year or 16,000 miles, whichever occurs first.
