Rainier AWD L6-4.2L (2007)
3. With the aid of an assistant, fully raise the headliner and install the left inboard sunshade retaining clip (5).
4. Install the right rear push pin (2)
5. Install the left rear push pin (3).
6. Install the assist handles to the roof panel.
7. Install the coat hooks to the roof panel.
8. Install the upper rear quarter trim panels.
9. Connect the navigation antenna electrical connector, if equipped.
10. Connect the rain sensor electrical connector, if equipped.
11. Connect the inside rear view mirror electrical connector (6).
12. If the vehicle is NOT equipped with a sunroof, seat the 2 interlocking strips (1).
13. If the vehicle is equipped with a sunroof, seat the 6 interlocking strips.
14. Reach underneath the carpet and remove the headliner harness electrical connector (1) from the instrument panel (I/P) wire harness.
15. Install the center pillar headliner harness electrical connector to the bussed electrical center, and the block base to the floor panel.
16. Install the headliner harness retaining clips (2) to the rocker panel and the floor panel.
