Rainier AWD L6-4.2L (2007)
11. Using the J 42450-A, clean the brake rotor to the rear axle flange contact area.
12. Refinish the rotor, if necessary. Refer to Brake Rotor Refinishing.
13. Inspect the park brake components. If any of the following conditions are found, replace the affected parts.
^
Bent or broken hold down spring
^
Broken, cracked, or worn brake shoe lining
^
Bent or damaged brake shoe
^
Worn, bent, or damaged backing plate
Installation Procedure
1. Clean the park brake shoes using denatured alcohol.
2. Dry the park shoes using non-lubricated, filtered air.
3. Lubricate the contact area between the park brake shoe and the backing plate with high temperature silicone brake lubricant.
Important: It maybe necessary to readjust the park brake shoes to allow the brake rotor to be reinstalled.
4. Adjust the park brake. Refer to Park Brake Adjustment.
Important: Ensure that the rotor to axle flange relationships marks are aligned, if the brake rotor has been refinished, after the brake
rotor is installed.
5. Install the brake rotor by slowly turning the rotor while pushing the rotor on the axle flange.
6. Install the rear brake caliper mounting bracket. Refer to Rear Brake Caliper Bracket Replacement.
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.
