Rainier AWD L6-4.2L (2007)
7. Remove the brake hose bolt from the brake caliper.
Important: The metal gaskets may be stuck to either the brake caliper or the brake hose end. Ensure that these gaskets are removed
from the brake hose end and the brake caliper.
8. Remove the copper gaskets from the brake hose end.
9. Discard the copper gaskets.
10. Remove and discard the copper gaskets.
Installation Procedure
Important: DO NOT reuse the old copper gaskets. Use only NEW copper gaskets.
1. Install the NEW copper gaskets to the rear brake caliper bolt.
Notice: Refer to Fastener Notice.
2. Install the rear brake hose to the rear brake caliper.
Tighten the rear brake bolt to 44 N.m (23 lb ft).
3. Remove the rubber plug and/or cap from the rear brake pipe fitting.
