Rainier AWD L6-4.2L (2007)
4. Install the brake pipe to the brake hose.
5. Using a backup wrench, install the rear brake pipe to the brake hose.
Tighten the rear brake pipe fitting to 20 N.m (18 lb ft).
6. Install the brake pipe retaining bolt at the frame.
Tighten the brake pipe retaining bolt to 20 N.m (18 lb ft).
7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.
