Rainier AWD L6-4.2L (2007)
Engine Mount: Service and Repair
Engine Mount and Bracket Replacement - Left
Engine Mount and Bracket Replacement - Left Side
Removal Procedure
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
2. Remove the cooling fan. Refer to Cooling Fan and Shroud Replacement.
3. Remove the manifold absolute pressure (MAP) sensor electrical connector and the retainer (1).
4. Remove the MAP sensor (2).
5. Remove the left shock module, if frame mount is being removed. Refer to Shock Module Replacement.
6. Remove the right and the left upper engine mount nuts (1).
7. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
8. Remove the right and the left lower engine mount nuts.
9. Remove the engine protection shield. Refer to Engine Protection Shield Replacement.
Important: When placing jack onto the oil pan, pay close attention to not damage the oil level sender.
10. Lower the vehicle and place a floor jack under the oil pan with a block of wood.
11. Raise the engine with the jack just enough to clear the engine mount stud.
