Rainier AWD L6-4.2L (2007)
3. Graphic shows left, right is similar.
Install the right engine mount bracket and secure with the bolts (1).
Tighten the engine mount bracket bolts to 50 N.m (37 lb ft).
4. Install the right engine mount.
Important: Ensure that the heat shield is located properly over the anti-rotation feature - right side only.
5. Lower the engine onto the engine mounts.
6. Install the right and the left upper engine mount nuts (1).
Tighten the upper engine mount nuts to 70 N.m (52 lb ft).
7. Raise the vehicle and remove the floor jack from under the vehicle.
8. Install the engine protection shield and secure with the bolts. Refer to Engine Protection Shield Replacement.
9. Install the right and the left lower engine mount nuts.
Tighten the lower engine mount nuts to 70 N.m (52 lb ft).
10. Lower the vehicle.
11. Install the right shock module. Refer to Shock Module Replacement.
12. Install the MAP sensor (2).
13. Install the MAP sensor retainer (1) and the electrical connector.
