Rainier AWD L6-4.2L (2007)
Important: The new actuator is in Bi-Level mode. Place the door in the middle of the travel position before you install the actuator.
1. Install the mode actuator (1).
Notice: Refer to Fastener Notice.
2. Install the screws to the mode actuator (1).
Tighten the screws to 1.9 N.m (18 lb in).
3. Install the left hand floor duct.
4. Install the left side sound insulator screws.
5. Recalibrate the mode actuator. Refer to Actuators Recalibration (Auxiliary HVAC) Actuators Recalibration (Primary) See: Testing and
Inspection/Programming and Relearning See: Testing and Inspection/Programming and Relearning
