Rainier AWD L6-4.2L (2007)
Air Door Actuator / Motor: Service and Repair
Recirculation Actuator Replacement
Recirculation Actuator Replacement
Removal Procedure
1. Remove the HVAC module assembly.
2. Remove the screws from the air inlet assembly.
3. Remove the air inlet assembly.
4. Disconnect the recirculation actuator electrical connector
5. Remove the recirculation actuator screws.
6. Remove the recirculation actuator.
Installation Procedure
1. Install the recirculation actuator.
2. Install the air inlet assembly.
Notice: Refer to Fastener Notice.
3. Install the recirculation actuator screws.
Tighten the screws to 1.9 N.m (17 lb in).
4. Connect the recirculation actuator electrical connector.
5. Install the HVAC module assembly.
6. Recalibrate the recirculation actuator on vehicles equipped with automatic climate control (C68). Refer to Actuators Recalibration (Primary). See:
Testing and Inspection/Programming and Relearning
