Rainier AWD L6-4.2L (2007)
Engine Control Module: Service and Repair
Powertrain Control Module Replacement
Service of the powertrain control module (PCM) should normally consist of either replacement of the PCM or electrically erasable programmable read
only memory (EEPROM) programming. If the diagnostic procedures call for the PCM to be replaced, the PCM should be inspected first to see if the
correct part is being used. If the correct part is being used, remove the faulty PCM and install the new service PCM.
Notice:
* Turn the ignition OFF when installing or removing the control module connectors and disconnecting or reconnecting the power to the control
module (battery cable, powertrain control module (PCM)/engine control module (ECM)/transaxle control module (TCM) pigtail, control module
fuse, jumper cables, etc.) in order to prevent internal control module damage.
* Control module damage may result when the metal case contacts battery voltage. DO NOT contact the control module metal case with battery
voltage when servicing a control module, using battery booster cables, or when charging the vehicle battery.
* In order to prevent any possible electrostatic discharge damage to the control module, do no touch the connector pins or the soldered components
on the circuit board.
* Remove any debris from around the control module connector surfaces before servicing the control module. Inspect the control module connector
gaskets when diagnosing or replacing the control module. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion
into the control module.
* The replacement control module must be programmed.
Important: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil
life, the engine oil life will default to 100 percent. If the replacement module is not programmed with the remaining engine oil life, the engine oil
will need to be changed at 5 000 km (3,000 mi) from the last engine oil change.
Removal Procedure
1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
2. Loosen the PCM harness connector bolts (4) from the center of the PCM harness connectors.
Notice: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.
3. Remove the PCM harness connectors (2) from the PCM (1).
4. Remove the PCM retaining bolts (3) and nuts (6).
Notice: Refer to PCM and ESD Notice.
5. Slide the PCM (1) away from the intake manifold past the mounting studs (5) and remove PCM from the vehicle.
6. Remove the PCM mounting studs (5) from the intake manifold only if replacing the studs.
Installation Procedure
