Rainier AWD L6-4.2L (2007)
Notice: Refer to Fastener Notice.
1. Install the PCM mounting studs (5) to the intake manifold, if removed.
Tighten the studs to 6 N.m (53 lb in).
2. Install the PCM (1) onto the studs (5).
3. Install the PCM retaining bolts (3).
Tighten the bolts to 8 N.m (71 lb in).
4. Install the PCM retaining nuts (6).
Tighten the nuts to 8 N.m (71 lb in).
5. Install the PCM harness connectors (2) to the PCM body.
6. Tighten the PCM harness connector retaining bolts (4).
Tighten the bolts to 8 N.m (71 lb in).
7. If a new PCM is being installed, the PCM must be programmed. Refer to Control Module References. See: Testing and Inspection/Programming
and Relearning