buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Symptoms - Data Communications|Page 8359 > < Symptoms - Data Communications|Page 8357
Page 5
background image

-

The HVAC control module

-

The HVAC control module - rear auxiliary

-

The inflatable restraint sensing and diagnostic module (SDM)

-

The instrument panel cluster (IPC)

-

The liftgate control module (LGM)

-

The passenger door module (PDM)

-

The powertrain control module (PCM)

-

The radio

-

The transfer case shift control module (TCSCM), w/4WD

3. The following DTCs may be retrieved with a history status, but are not the cause of the present condition.

-

U1300

-

U1301

-

U1305

6. A state of health (SOH) DTC with a history status may be present along with a U1000 code having a current status. This indicates that the

malfunction occurred when the ignition was ON.

7. Data link connector terminals 2 and 5 provide the connection to the class 2 serial data circuit and the signal ground circuit respectively.

10. A poor connection at DLC terminal of the splice pack SP205 would cause this condition but will not set a DTC.
11. An open in the class 2 serial data circuit between the DLC and splice pack SP205 will prevent the scan tool from communicating with any module.

This condition will not set a DTC.

12. The class 2 serial data circuit is shorted to voltage or ground. The condition may be due to the wiring or due to a malfunction in one of the

modules. When testing the wire for a short, make sure there is not a module connected to the wire being tested. This test isolates the BCM and the
PCM class 2 serial data circuits.

13. This test isolates the BCM class 2 serial data circuits.
16. The BCM detects that the ignition is ON and sends the appropriate power mode message to the other modules. Therefore, the BCM must remain

connected to the DLC for any other module to communicate with the scan tool. This test isolates the splice pack SP306 serial data circuits.

21. This test isolates the rest of the splice pack SP205 serial data circuits.
25. If there are no current DTCs that begin with a "U", the communication malfunction has been repaired.
26. The communication malfunction may have prevented diagnosis of the customer complaint.

Symptoms - Data Communications|Page 8359 > < Symptoms - Data Communications|Page 8357