Rainier AWD L6-4.2L (2007)
Impact Sensor: Service and Repair
Inflatable Restraint Side Impact Sensor Replacement
Inflatable Restraint Side Impact Sensor Replacement
Removal Procedure
Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is
securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR
system repairs.
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the front door trim panel.
3. Peel the rear half of the water deflector away from the door in order to access the side impact sensor.
4. Remove the screws that retain the side impact sensor (2) to the door.
5. Disconnect the impact sensor electrical connector (1) from the side impact sensor.
6. Remove the side impact sensor from the door.
Installation Procedure
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Position the side impact sensor (2) horizontally to the door.
3. Connect the electrical connector (1) to the side impact sensor (2).
Notice: Refer to Fastener Notice.
4. Install the screws which retain the side impact sensor to the door.
Tighten the screws to 8 N.m (71 lb in).
5. Fully seat the water deflector to the door.
6. Install the door trim panel.
7. Enable the SIR system. Refer to SIR Disabling and Enabling.
