Rainier AWD L6-4.2L (2007)
Child Seat Tether Attachment: Service and Repair
Child Restraint Tether Anchor Replacement - Rear No. 1
Child Restraint Tether Anchor Replacement - Rear No. 1
Removal Procedure
1. Open the liftgate.
2. Remove the bolt that retains the child restraint tether anchor to the floor panel.
3. Remove the child restraint tether anchor from the floor panel.
Installation Procedure
1. Install the child restraint tether anchor to the floor with the pivot point of the anchor ring indexed toward the front of the vehicle.
Notice: Refer to Fastener Notice.
2. Install the bolt that retains the child restraint tether anchor to the floor panel.
Tighten the child restraint tether anchor bolt to 35 N.m (26 lb ft).
3. Close the liftgate.