Rainier AWD L6-4.2L (2007)
Impact Sensor: Service and Repair
Inflatable Restraint Vehicle Rollover Sensor Replacement
Inflatable Restraint Vehicle Rollover Sensor Replacement
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Fold back the rear carpet in order to gain access to the sensor. Refer to Rear Floor Panel Carpet Replacement.
3. Disconnect the electrical connector.
4. Remove the nuts securing the rollover sensor to the floor panel.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the nuts securing the rollover sensor to the floor panel.
Tighten the screws to 10 N.m (88 lb in).
2. Connect the electrical connectors.
3. Install the rear carpet.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.
